Software for BE Series
Version 5.12
Release Notes
Read this before using BE series.
This document describes important information supplementary to the Instruction
Manual for use of BE and BES series. Be sure to read through the document.
Software with new functions accompanying this machine is available for operation improvement.
Be sure to observe the following to take full advantage of BE and BES software
with regard to functions and features.
| * |
Do not start other software while the Embroidery Machine Controller is used. |
| * |
Cancel the screen saver setting. |
| * |
Do not set the system agent contained in the Windows. |
| * |
Turn off the power of the machine after upgrading the software. |
| * |
There is a case that the dialog of SETUP COMPLETE may not be show clearly on display due to blue color back ground block the distinction. |
In case only such back ground is shown and kept on display for a while,
Please click the left button on the mouse so that the dialog of SETUP COMPLETE
can be shown in good order.
 Changes in ver.5.12
GENERAL
As regards the delete short stitches function, we have changed to set the default value to be 0.5mm for all the models.
For the single head PC Spec. machine, we have corrected the way how to enter inching mode in accordance with our instruction manual.
Some color samples, such as Robinson-Anton was added to function of "Changing display colors".
Rectified the fatal error which existed in the ver.5.10 & 5.11.
The error was that embroidery machine controller is uncommonly closed.
Machine program version
[BE-0901E-AC,BE-1201B-AC]
Main-CPU ROM version:d-2.03(102)
Hoop Control Data Table version:A-1.00(65)
Main Shaft-CPU ROM version:99(67)
I/F-CPU ROM version:Q-4.00(81)
Head-CPU ROM version:2
PC-PANEL-CPU ROM version:2
[Release Notes of Previous Versions]
|
|
|
|
|
|
|
|
